My FSX, A2A 172, Saitek pedals, yoke (3 modes) and radio panel were working perfectly. I had set them up using FSUIPC and Linda.
Then I found out my 172 version was 1.0 and there was an update available. I ran it. Now I have lost mode 1 and 2 on the yoke and the plane is rolling hard right. The yoke in the plane is in a right bank position at rest in a cold plane but from outside the ailerons are in neutral position.
It took me a week to get everything set up and running. Now I'm back to square one. Has anyone had this issue?
Problems after updating
- Lewis - A2A
- A2A Lieutenant Colonel
- Posts: 33321
- Joined: 06 Nov 2004, 23:22
- Location: Norfolk UK
- Contact:
Re: Problems after updating
Hello,
have you reset the mappings up, checked the aircraft config tool etc?
thanks,
Lewis
have you reset the mappings up, checked the aircraft config tool etc?
thanks,
Lewis
A2A Facebook for news live to your social media newsfeed
A2A Youtube because a video can say a thousand screenshots,..
A2A Simulations Twitter for news live to your social media newsfeed
A2A Simulations Community Discord for voice/text chat
A2A Youtube because a video can say a thousand screenshots,..
A2A Simulations Twitter for news live to your social media newsfeed
A2A Simulations Community Discord for voice/text chat
Who is online
Users browsing this forum: No registered users and 29 guests