VOR 1and 2
VOR 1and 2
Is there anyway to increase the sensitivity for both? They lag when approaching a radial then completely go to full deflection. They go from not moving to moving ridiculously fast which always makes me over shoot. Also when using Autopilot with the heading bug it lags about 5 seconds behind after turning the obs to desired heading. Screws up my hold or dme arcs. Aircraft reacts really slow in Autopilot using the heading bug for turns.
Re: VOR 1and 2
I think this is just the industry standard CDI for the VOR: 2°/'dot', 10° for full-scale deflection. Or did I misunderstand something?
Effectively what you describe is what happens when you capture the radial close to the station with a large angle.
-Esa
Effectively what you describe is what happens when you capture the radial close to the station with a large angle.
-Esa
- Nick - A2A
- A2A Captain
- Posts: 13773
- Joined: 06 Jun 2014, 13:06
- Location: UK
Re: VOR 1and 2
Yes, sounds like that to me too. The CDI needles in the A2A GA fleet are perhaps the smoothest you'll find in terms of their animation: I believe they use some custom code to eliminate the jerky CDI movement we see by default in FSX/P3D (even with '3-D' gauges) if crossing a radial.AKar wrote:Effectively what you describe is what happens when you capture the radial close to the station with a large angle.
If FPS are very low, perhaps that could present a problem though. For instance, I think the autopilot simulation tends to need a frame rate of at least 20ish for best performance.
Thanks,
Nick
Re: VOR 1and 2
The closer you get to your radial the needle should start moving. This doesn't happen. It goes from still to full deflection. Like there was a delay. Even when I'm tracking loc inbound, if I'm a little to the left of loc and I try correct it doesn't move then once on the radial it deflects the other way.
- Nick - A2A
- A2A Captain
- Posts: 13773
- Joined: 06 Jun 2014, 13:06
- Location: UK
Re: VOR 1and 2
Have to say, I've never had any problems with the CDI or glideslope needles being unresponsive in various FSX and P3D installations. What sort of frame rate are you seeing in your host sim? And do you see this behaviour regardless of the distance to the navaid? (Say at 10 miles?)
Nick
Nick
Re: VOR 1and 2
Can you give any specific example? With details of where this happens.lifendet wrote:The closer you get to your radial the needle should start moving. This doesn't happen. It goes from still to full deflection. Like there was a delay. Even when I'm tracking loc inbound, if I'm a little to the left of loc and I try correct it doesn't move then once on the radial it deflects the other way.
-Esa
Who is online
Users browsing this forum: No registered users and 15 guests