New P3Dv4 GTN 750 Issue

[joepoway]

I just installed the new Flight 1 GTN 750 for P3Dv4 and have an issue with installing it into my P3Dv4 C172. When I open the C172 Aircraft Configurator_P3D it only addresses the P3Dv3 install of my C172. The header of the app when I open it says: C172 Aircraft Configurator (Prepar3D) however when I open my T6 configurator it says: T6 ...(Prepar3D v4). Ironically there is no P3Dv3 of my T6 anymore unless that version handles both v3 and v4?

I have installed both the new versions for P3Dv4 and still have both original versions installed in P3Dv3. I used the recommended approach of installing them into the P3Dv4 Add-ons folder outside of P3Dv4 and they both operate fine.

Please advise on how to get the new GTN 750 incorporated into my C172 in P3Dv4 ?

Thanks in advance
Joe

[Maxpower2k]

Same here. The 750 shows up in the 182, but a blank screen. Not sure why it's not working. I was so excited that the new version was out to work with P3DV4. Anyone?

[Lewis - A2A]

Hello,

go to where you installed the aircraft and go to A2A>C182>Tools.

Please note though we have not yet tested or officially updated for use with the new P3Dv4 GPS units.

thanks,
Lewis

[webestereo]

Did that worked with those instructions above(Config panel via Tool config utility)?

I wonder if messing with that or better wait for official release----- All right, i feel like i want to mess a bit...

[Nightliner76]

Same problem here...