Prepar3d v3 Content errors + Saitek Panel Issues

[Fazza68]

Hi

I upgraded to Prepar3d v3.4. from v2.2. However, when I re-installed c172 trainer I have some funky issues with my Saitek Proflight Panels only in the C172. I also get some content error warnings when exiting Prepar3d.

System:
Windows 10, Prepare3D V.3.4, SPAD v0.5.0, FSUIPC 4.9490, A2A C172 Training Academic V2. I have all simconnects installed I think.

Saitek Issues:
1. Proflight Radio: I can change the ADF frequency on Saitek but it doesn't change on the radio in the cockpit but if I change it in the cockpit it changes it on the Saitek radio.
2. Proflight Multi-panel: when changing the HDG the increments are now in 45 degrees instead of 1 degree increments.

(I do not have any of these issues with the stock microsoft cessna in prepar3D)


Content Errors Warning When Closing Prepar3D

see log below:


[error.6]
error=Gauge file not found: A2A_C172!blackout
[error.7]
error=Gauge file not found: rxpGNS!GNS530
[error.8]
error=Gauge file not found: rxpGNS!GNS430
[error.9]
error=Gauge file not found: rxpGNS!GNS430
[error.10]
error=Gauge file not found: rxpGNS!GNS530
[error.11]
error=file "null(.wav|.ogg)" not found
[error.12]
error=file "null(.wav|.ogg)" not found
[error.13]
error=file "null(.wav|.ogg)" not found
[error.14]
error=file "null(.wav|.ogg)" not found
[error.15]
error=Gauge file not found: rxpGNS!GNS530
[error.16]
error=Gauge file not found: rxpGNS!GNS430
[error.17]
error=Taxiway path with 0 width
[error.18]
error=Taxiway path with 0 width
[error.19]
error=Taxiway path with 0 width
[error.20]
error=Taxiway path with 0 width
[error.21]
error=Taxiway path with 0 width
[error.22]
...... the errors actually go to error.107 but I deleted them to not take up too much space.

I would really appreciate some assistance!

[Lewis - A2A]

Hello and welcome to the forums,

For the error log, that should be turned off. Its an old part of the FSX/P3D code that was used for dev purposes way back when but doesn't really work anymore as you have seen as it throws up errors all over the shop working or otherwise. Its not really for end users to use.

For your hardware, how are you controlling it, are you using Spad next?

For the 172 are you all updated with the latest Accu-sim updater?
http://a2asimulations.com/forum/viewtop ... 23&t=57819

thanks,
Lewis

[Fazza68]

Thanks Lewis. Content errors fixed now by turning off the logging. Also after upgrading to the latest update for C172
the HDG bug issue on the Saitek fixed. I am using SPAD. Still can't get the the ADF on Saitek radio to change the radio
in the cockpit. Is this something that could be looked into?

[Lewis - A2A]

The Spad guys where recently looking into something.

thanks,
Lewis