Help A2A! Whole Avionics Suite Dead

[cflord]

After installing the Core Accu-Sim Update v.1.5.2 for my P-40 and P-51 the whole avionics suite in my C172R is dead. I have the engine running, Bat & Gen switches "ON", Avionics switches "ON", all Radios (Comm & Nav) "ON", and Transponder "ON". The avionics suite will not power up. No problems shown in Maintenance Hanger. The other problem I found after the Accu-Sim Core Update is this: When bringing the airplane up in FSX with the engine running the Fuel Shut Off lever comes up in the "Pull" / "Off" position, causing the engine to run rough and guit. This did not happen before the update. Any help you could give me would be greatly appreciated. It's no fun flying blind in the weather!

Keep the shiny side up and the dirty side down!

Ret SMSgt Cliff Lord - C-130 Flight Engineer -& Mechanic

[rafgath]

Install last update 1.03 for Cessna once again. Should help

[Lewis - A2A]

Install last update 1.03 for Cessna once again. Should help

Spot on. The 1.03 is a test patch so outside of the core system and will want installing last as noted on the download page. Eventually this will be streamlined into the core updates.


Sent from my iPhone using Tapatalk - now Free

[cflord]

Reinstalling update 1.03 fixed the avionics problem. When bringing the airplane up in FSX with the engine running the Fuel Shut Off lever still comes up in the "Pull" / "Off" position, causing the engine to run rough and guit. I can live with the Fuel Shut Off problem, as long as I have my avionics! Thanks guys for your guick help.

Keep the shiny side up and the dirty side down!

Ret SMSgt Cliff Lord - C-130 Flight Engineer & Mechanic

[Lewis - A2A]

Check your default flight for the fuel
Cut off, it could be bringing that setup across from the default flight.

Thanks,
Lewis


Sent from my iPhone using Tapatalk - now Free