Problems with the C172 Trainer

[kokorim]

Hi.
I recently bought the A2A C172 Trainer version.
When I downloaded it it all went fine but when I restarted my computer and opened FSX I could load the airplane but I did not see the exterior, I could just saw the cockpit that didn't worked so well.
Than when I press SHIFT+7 the Maintenance Hangar won't show up

P.S: I did downloaded the DirectX 9.

Koko.

[Lewis - A2A]

Hello Koko,

It sounds like you haven't updated your FSX. Make sure your FSX is updated using the two service packs from Microsoft.

Thanks,
Lewis

[kokorim]

thanks sir for the fast reply but i actually verified that i got sp1 and sp2.
so it isn't that

[kokorim]

ok after i reintalled the sp's it worked but i have gor a problem with the elevator, the trim, and the aircraft goes always to the left even whe there is more fuel in the right side than in the left one

[Oracle427]

If you are finding that the aircraft wants to roll to the left that is normal. I have done a couple of RL flights this week and paid extra close attention to my yoke position and found that it is "neutral" with a slight right aileron input to keep the wings level.

[Lewis - A2A]

Yes so it sounds like your SP was corrupt or not correctly applied glad to hear it's sorted. As for aircraft behaviour we have brought all new realism to the land of FS with the C172 so it will surprise users use to sims performing a certain way.

Thanks,
Lewis

[kokorim]

In way to succesfully make the aircraft work i had to activate DirectX 10 in the FSX but my ENB series weren't working with that activated so my question is if A2A cessna 172 Trainer can work with that deactivated?
Thanks
Koko

[Lewis - A2A]

Yes so long as your direct X9 is updated otherwise you will for sure get crashes.

Thanks,
Lewis